Silentwind Parts

Nose cone for Silentwind Wind Turbine

Run/Stop Switch with Face Plate, 15' 14-3 wire and interconnect terminal block for use with 3 phase wild AC wind generator 400W or less. It allows remote wind generator Stop/ Run switch to be located in an easy to access area.Good for use on Rutland 1200 and Silent Wind Generators only.

BEARING - SHIELDED  Replacement inside Axis bearing for Air X, Air Breeze, Air 30, Air 40, Silent Wind & Air 403 wind generators. (1) Sealed/Shield Bearing Only

Replacement YAW bearing for Air X, Air Breeze, Air 30, Air 40, Silent Wind & Air 403 wind generators.  (1) Yaw Bearing sealed Marine Manufacturer item # 3-CABR-1000

The bearing spacer is 2 mm thick that sits between the front and internal axis bearings on the Air series of wind generators and SilentWind turbine products.  Sold as individual items, but 2 are required to meet the wind turbines 4 mm thickness on all products. Please order 2 at a time for full bearing spacer replacement. Part Number: 3-CAOT-1227

The spacer bearing is 2 mm thick that sits between the front and internal axis bearings on the Air when generators and SilentWind turbine products.  Sold as individual items, but to a required to meet the wind turbines 4 mm thickness on all products. Please order 2 at a time for full bearing spacer replacement. Part Number: CAOT-1005

Yaw Neoprene Pad sits between the yaw mounting clamp and mast to help provide vibration dampening.  Fits most wind generators that mount on to a 1.5" schedule 40 pipe (OD 1.9"). Neoprene Yaw Pad (2" X 6" X .13" Thick) for Air Breeze (Marine & Land), Air-X (Marine & Land), Air 40, and Air 30 Part # 3-CAOT-1022

This high tech wind generator Blade Kit  allows for upgrade of all  existing Air Breeze, Air-X, Silent Air-X, Air-30, Air-40, Silentwind wind generators (12-24-48V) to the latest in high performance blades. The trendy distinctive Blue-White-Gray colored high-tech carbon fiber blades maximizes the capturing of wind energy with minimal noise.  The Wind Generator Blade Kit includes 3 balanced carbon fiber blades that are Blue with White and Gray stripes. Included in...

The Silentwind charge controller HYBRID BOOST is a combined wind and solar charge controller with an inbuilt micro-controller. The HYBRID BOOST was especially developed for the Silentwind Generator and enables you to additionally install solar panels up to a wattage of 300 Watt peak or to a maximum current of 20A. If you are using the ‘Load’ outputs, the charge controller can be configured to automatically switch off those outputs before the batteries are too deeply discharged, or turn on a...

Brush Assembly for Silentwind Wind TurbineManufacturer Part Number: SW406

Interface PCB  for Silentwind Wind TurbineManufacturer Part Number: SW402

O-Ring for Silentwind Wind TurbineManufacturer Part Number: SW202

Replacement Slip Ring assembly  for Silentwind Wind Turbines.  Includes 12AWG fling leads.  (no YAW hardware included) Manufacturer Part Number: SW601

Stator Assembly for Silentwind Wind TurbineManufacturer Part Number: SW204

Yaw Assembly for Silentwind Wind Turbine.  Kit includes:  Yaw Snap Ring, Yaw Clamp, Yaw Body, (4) M6x35 SS Screws, (4) M6 SS Locking Nuts & Mast Damping Pad (no Slip Ring or Bearing, sold seperatly) Manufacturer Part Number: SW602