We are pleased to offer a series of low cost analog control panels to support on-board wind turbines. It is easy to install and will result in a professional operator station enhancing the beauty and value of your vessel, RV or remote home . It helps to reduce installation costs and makes wiring a snap with just 4 wires to connect. The e10 panel is available in four sizes (5A, 10A, 25A & 40A) that will support 12-48V DC system.
The e10 CONTROL PANEL operates and monitors the wind turbine. It is equipped with power On/Off circuit breaker, analog ammeter indicating wind turbine current production and a Stop/Run switch for direct control of the turbine. A clearly marked rear terminal block is provided for easy interconnect of the two turbine wires and two battery power wires. Panel is fully calibrated and ready for installation.
Recommended to use:
5A with 48V Air Breeze
10A with 24V Air Breeze or 48V Air X
25A with 12V Air Breeze or 24V Air X
* Please call for technical advice on matching this control panel to your particular wind generator should you have any questions.
These panels are designed to work with wind generators that have DC output (two wires). Cannot be used with wind generators that have a three wire output (wild AC). The control panel has no built-in battery charging regulation and therefore the wind generator must be equipped with its own regulator so that the batteries will not overcharge.
The optional heavy duty plastic enclosure is made with Acrylonitrile Butadiene Styrene (ABS). The dimensions is 6.6" x 4.2" x 2.1". For more information, click Here.
Note:
10A rated panel is protected with a 10A circuit breaker and has a 0-8A panel meter
25A rated panel is protected with a 25A circuit breaker and has a 0-15A panel meter
40A rated panel is protected with a 40A circuit breaker and has a 0-30A panel meter