Wind Turbine Control Panel 12 Volt 100 Amp

e10 Control Panel
Wind Turbine Control Panel

If you need to control both wind and solar see our e20 PANEL models.

The e10 Wind Turbine Control Panel  It is pre-engineered to make wiring the wind turbine easy - just attach two wires from your battery  and two wires from the turbine to the large clearly labeled terminals. It could not be simpler. The flush mount panel includes a pre-wired "Stop / Run Switch" with noise suppressors, Digital Power-Energy Meter (displays Voltage, Current and Energy production)  and Circuit Breaker. The panel comes complete with instructions and is pre-calibrated and ready to use.

Recommended for use with the Air Dolphin or any other wind turbines that has a built-in regulator and a output current of 100 amps or less for a 12 V nominal DC system. Turbines without built-in regulators can also be used provided a diversion load controller is installed on the battery bank. Control panel includes Instructions and mounting template.

e10 Enclosed Version – the e10 panel is available in a self-contained enclosure. The enclosure is non-corrosive, water resistant and comes with the e10 panel mounted and sealed. Three watertight non-corrosive cable connectors are also included. Requires four mounting screws to secure in place (not included). Feed through holes for wire cable clamps must be drilled (13/16”) into the enclosure leaving complete versatility to the installer for wire entry location.