Wind Turbine Control Panel 24 Volt 100 Amp

e10 Control Panel
Wind Turbine Control Panel

The e10 Wind Turbine Control Panel  It is pre-engineered to make wiring the wind turbine easy - just attach two wires from your battery  and two wires from the turbine to the large clearly labeled terminals. It could not be simpler. The flush mount panel includes a pre-wired "Stop / Run Switch" with noise suppressors, Digital Power-Energy Meter (displays Voltage, Current and Energy production)  and Circuit Breaker. The panel comes complete with instructions and is pre-calibrated and ready to use.

Recommended for use with the American Zephyr Airdolphin Mark Zero or any other wind turbines that has a built-in regulator and a output current of 100 amps or less for a 24 V nominal DC system. Turbines with out built-in regulators can also be used provided a diversion load controller is installed on the battery bank. Control panel includes Instructions and mounting templete.

Save $$$ on e10 Wind Turbine Control Panel when ordered with an Air-X, Air Breeze or Rutland 913 Wind Turbine combo kits.

e10 Enclosed Version – the e10 panel is available in a self-contained enclosure. The enclosure is non-corrosive, water resistant and comes with the e10 panel mounted and sealed. Three watertight non-corrosive cable connectors are also included. Requires four mounting screws to secure in place (not included). Feed through holes for wire cable clamps must be drilled (13/16”) into the enclosure leaving complete versatility to the installer for wire entry location.